Comparison of real-time instruments and gravimetric method when measuring particulate matter in a residential building

This study used several real-time and filter-based aerosol instruments to measure PM_2.5 levels in a high-rise residential green building in the Northeastern US and compared performance of those instruments. PM_2.5 24-hr average concentrations were determined using a Personal Modular Impactor (PMI) with 2.5 µm cut (SKC Inc., Eighty Four, PA) and a direct reading pDR-1500 (Thermo Scientific, Franklin, MA) as well as its filter. 1-hr average PM_2.5 concentrations were measured in the same apartments with an Aerotrak Optical Particle Counter (OPC) (model 8220, TSI, Inc., Shoreview, MN) and a DustTrak DRX mass monitor (model 8534, TSI, Inc., Shoreview, MN). OPC and DRX measurements were compared with concurrent 1-hr mass concentration from the pDR-1500. The pDR-1500 direct reading showed approximately 40% higher particle mass concentration compared to its own filter (n = 41), and 25% higher PM_2.5 mass concentration compared to the PMI_2.5 filter. The pDR-1500 direct reading and PMI_2.5 in non-smoking homes (self-reported) were not significantly different (n = 10, R² = 0.937), while the difference between measurements for smoking homes was 44% (n = 31, R² = 0.773). Both OPC and DRX data had substantial and significant systematic and proportional biases compared with pDR-1500 readings. However, these methods were highly correlated: R² = 0.936 for OPC versus pDR-1500 reading and R² = 0.863 for DRX versus pDR-1500 reading. The data suggest that accuracy of aerosol mass concentrations from direct-reading instruments in indoor environments depends on the instrument, and that correction factors can be used to reduce biases of these real-time monitors in residential green buildings with similar aerosol properties.

Implications: This study used several real-time and filter-based aerosol instruments to measure PM_2.5 levels in a high-rise residential green building in the northeastern United States and compared performance of those instruments. The data show that while the use of real-time monitors is convenient for measurement of airborne PM at short time scales, the accuracy of those monitors depends on a particular instrument. Bias correction factors identified in this paper could provide guidance for other studies using direct-reading instruments to measure PM concentrations.     

Biodegradability of the anticancer drug etoposide and identification of the transformation products

Etoposide susceptibility to microbiological breakdown was studied in a batch biotransformation system, in the presence or absence of artificial wastewater containing nutrients, salts and activated sludge at two concentration levels. The primary focus of the present study was to study etoposide transformation products by ultra-high performance liquid chromatography coupled to high-resolution hybrid quadrupole-Orbitrap tandem mass spectrometry (MS/MS). Data-dependent experiments combining full-scan MS data with product ion spectra were acquired to identify the molecular ions of etoposide transformation products, to propose the molecular formulae and to elucidate their chemical structures. Due to the complexity of the matrix, visual inspection of the chromatograms showed no clear differences between the controls and the treated samples. Therefore, the software package MZmine was used to facilitate the identification of the transformation products and speed up the data analysis. In total, we propose five transformation products; among them, four are described as etoposide transformation products for the first time. Even though the chemical structures of these new compounds cannot be confirmed due to the lack of standards, their molecular formulae can be used to target them in monitoring studies.     

Heavy metal contamination in sediments of an artificial reservoir impacted by long-term mining activity in the Almadén mercury district (Spain)

Sediments from the Castilseras reservoir, located downstream on the Valdeazogues River in the Almadén mercury district, were collected to assess the potential contamination status related to metals(oids) associated with river sediment inputs from several decommissioned mines. Metals(oids) concentrations in the reservoir sediments were investigated using different physical and chemical techniques. The results were analyzed by principal component analysis (PCA) to explain the correlations between the sets of variables. The degree of contamination was evaluated using the enrichment factor (EF) and the geoaccumulation index (Igeo). PCA revealed that the silty fraction is the main metals(oids) carrier in the sediments. Among the potentially harmful elements, there is a group (Al, Cr, Cu, Fe, Mn, Ni, and Zn) that cannot be strictly correlated to the mining activity since their concentrations depend on the lithological and edaphological characteristics of the materials. In contrast, As, Co, Hg, Pb, and S showed significant enrichment and contamination, thus suggesting relevant contributions from the decommissioned mines through fluvial sediment inputs. As far as Hg and S are concerned, the high enrichment levels pose a question concerning the potential environmental risk of transfer of the organic forms of Hg (mainly methylmercury) from the bottom sediments to the aquatic food chain.     

Utilizing international networks for accelerating research and learning in transformational sustainability science

A promising approach for addressing sustainability problems is to recognize the unique conditions of a particular place, such as problem features and solution capabilities, and adopt and adapt solutions developed at other places around the world. Therefore, research and teaching in international networks becomes critical, as it allows for accelerating learning by sharing problem understandings, successful solutions, and important contextual considerations. This article identifies eight distinct types of research and teaching collaborations in international networks that can support such accelerated learning. The four research types are, with increasing intensity of collaboration: (1) solution adoption; (2) solution consultation; (3) joint research on different problems; and (4) joint research on similar problems. The four teaching types are, with increasing intensity of collaboration: (1) adopted course; (2) course with visiting faculty; (3) joint course with traveling faculty; and (4) joint course with traveling students. The typology is illustrated by extending existing research and teaching projects on urban sustainability in the International Network of Programs in Sustainability, with partner universities from Europe, North America, Asia, and Africa. The article concludes with challenges and strategies for extending individual projects into collaborations in international networks.     

Alternative management structures for municipal waste collection services: The influence of economic and political factors

Identifying and characterising the factors that determine why a local authority opts for a particular way of managing its waste collection service is an important issue, warranting research interest in the field of municipal solid waste (MSW) management. This paper presents empirical evidence spanning a broad time horizon (2002–2010) showing that economic and political factors impact in different ways on the provision of waste management services. We examine five alternatives in this area, including public and private service delivery formulas and, within each field, individual and joint options. Our findings highlight the importance of the service cost and that of the various indicators of fiscal stress as determinant factors of management decisions regarding the provision of MSW management services.     

Formation of indoor nitrous acid (HONO) by light-induced NO<Subscript>2</Subscript> heterogeneous reactions with white wall paint

Gaseous nitrogen dioxide (NO₂) represents an oxidant that is present in relatively high concentrations in various indoor settings. Remarkably increased NO₂ levels up to 1.5 ppm are associated with homes using gas stoves. The heterogeneous reactions of NO₂ with adsorbed water on surfaces lead to the generation of nitrous acid (HONO). Here, we present a HONO source induced by heterogeneous reactions of NO₂ with selected indoor paint surfaces in the presence of light (300 nm?<?λ?<?400 nm). We demonstrate that the formation of HONO is much more pronounced at elevated relative humidity. In the presence of light (5.5 W m^?2), an increase of HONO production rate of up to 8.6?·?10⁹ molecules cm^?2 s^?1 was observed at [NO₂]?=?60 ppb and 50 % relative humidity (RH). At higher light intensity of 10.6 (W m^?2), the HONO production rate increased to 2.1?·?10¹⁰ molecules cm^?2 s^?1. A high NO₂ to HONO conversion yield of up to 84 % was observed. This result strongly suggests that a light-driven process of indoor HONO production is operational. This work highlights the potential of paint surfaces to generate HONO within indoor environments by light-induced NO₂ heterogeneous reactions.     

Frequency of micronuclei and of other nuclear abnormalities in erythrocytes of the grey mullet from the Mondego,Douro and Ave estuaries—Portugal

Fish are bioindicators of water pollution, and an increased rate of their erythrocyte nuclear morphological abnormalities (ENMAs)—and particularly of erythrocyte micronuclei (EMN)—is used as a genotoxicity biomarker. Despite the potential value of ENMAs and MN, there is scarce information about fish captured in Iberian estuaries. This is the case of the Portuguese estuaries of the Mondego, Douro and Ave, suffering from different levels of environmental stress and where chemical surveys have been disclosing significant amounts of certain pollutants. So, the aim of this study was to evaluate genotoxicants impacts and infer about the exposure at those ecosystems, using the grey mullet (Mugil cephalus) as bioindicator and considering the type and frequency of nuclear abnormalities of erythrocytes as proxies of genotoxicity. Sampling of mullets was done throughout the year in the important Mondego, Douro and Ave River estuaries (centre and north-western Portugal). The fish (total n?=?242) were caught in campaigns made in spring–summer and autumn–winter, using nets or fishing rods. The sampled mullets were comparable between locations in terms of the basic biometric parameters. Blood smears were stained with Diff-Quik to assess the frequencies of six types of ENMAs and MN (given per 1,000 erythrocytes). Some basic water physicochemical parameters were recorded to search for fluctuations matching the ENMAs. Overall, the most frequent nucleus abnormality was the polymorphic type, sequentially followed by the blebbed/lobed/notched, segmented, kidney shaped, vacuolated, MN and binucleated. The total average frequency of the ENMAs ranged from 73?‰ in the Mondego to 108?‰ in the Ave. The polymorphic type was typically ≥50 % of the total ENMAs, averaging about 51?‰, when considering all three estuaries. The most serious lesion—the MN—in fish from Mondego and Douro had a similar frequency (≈0.38?‰), which was significantly lower than that in the Ave (0.75?‰). No significant seasonal differences existed as to the MN rates and seasonal differences existed almost only in the Douro, with the higher values in AW. In general, the pattern of ENMAs frequencies was unrelated with the water physicochemical parameters. Considering the data for both the total ENMAs and for each specific abnormality, and bearing in mind that values of MN in fish erythrocytes >0.3?‰ usually reflect pollution by genotoxicants, it is suggested that mullets were likely being chronically exposed to such compounds, even in the allegedly less polluted ecosystem (Mondego). Moreover, data supported the following pollution exposure gradient: Mondego?<?Douro?<?Ave. The scenario and inferences nicely agree with the published data from chemical monitoring.     

Sediments as a sink for UV filters and benzotriazoles: the case study of Upper Iguaçu watershed,Curitiba (Brazil)

Ingredients in home and personal care products, including UV filters and benzotriazoles, are high production volume chemicals extensively used in our daily life, despite several studies revealed their potential eco-toxicity and endocrine-disrupting capacity. Due to some features, such as high lipophilicity, low degradability, and persistence of many of these compounds, sediments can be considered a sink for them in the aquatic environment. In the present study, nine organic UV filters and three benzotriazoles were investigated for the first time in sediments from four urban rivers in Brazil. The contaminants were analyzed by liquid chromatography-tandem mass spectrometry (LC-MS/MS). The results revealed that octocrylene (OC), etylhexyl-methoxycinnamate (EHMC), benzophenone-3 (oxybenzone, BP3), and benzotriazole (BZT) were the predominant compounds adsorbed on the sediments, with concentrations ranging from 5.6 to 322.2 ng g⁻¹ dry weight. The results reported in this work constitute the first data on the accumulation of polar benzotriazoles and lipophilic organic UV filters in sediments from Brazil.

     

Chitosan/Hydrophilic Plasticizer-Based Films: Preparation,Physicochemical and Antimicrobial Properties

The addition of plasticizers to biopolymer films is a good method for improving their physicochemical properties. The aim of this study was to evaluate the effect of chitosan (CHI) blended with two hydrophilic plasticizers glycerol (GLY) and sorbitol (SOR), at two concentrations (20 and 40 wt%) on their mechanical, thermal, barrier, structural, morphological and antimicrobial properties. The chitosan was prepared through the alkaline deacetylation of chitin obtained from fermented lactic from shrimp heads. The obtained chitosan had a degree of deacetylation (DA) of 84 ± 2.7 and a molecular weight of 136 kDa, which indicated that a good film had formed. The films composed of CHI and GLY (20 wt%) exhibited the best mechanical properties compared to the neat chitosan film. The percentage of elongation at break increase to over 700 % in the films that contained 40 % GLY, and these films also exhibited the highest values for the water vapor transmission rate (WVTR) of 79.6 ± 1.9 g m² h^?1 and a yellow color (b _o  = 17.9 ± 2.0) compared to the neat chitosan films (b _o  = 8.8 ± 0.8). For the structural properties, the Fourier transform infrared spectroscopy (FTIR) and X-ray diffraction analyses revealed an interaction in the acetamide group and changes in the crystallinity of plasticized films. The scanning electron micrographs revealed that all formulations of the chitosan films were smooth, and that they did not contain aggregations, pores or microphase separation. The thermal analysis using differential scanning calorimetry (DSC) revealed a glass transition temperature (Tg) of 130 °C for neat chitosan film, but the addition of SOR or GLY elicited a decrease in the temperature of the peak (120 °C). In addition, the antimicrobial activity of the chitosan films was evaluated against Listeria monocytogenes, and reached a reduction of 2 log after 24 h. The plasticizer concentration of 20 % GLY is sufficient for obtaining flexible chitosan films with good mechanical properties, and it could serve as an alternative as a packaging material to reduce environmental problems associated with synthetic packaging films.     

Energy policy evaluation in practice: the case of production subsidies and DEN-B in the Netherlands

This paper describes how energy policy can be evaluated in practice. The goal is to make policy makers aware of how an evaluation can be based on scientific principles and to help economists appreciate how an evaluation can be performed if strong empirical evidence is lacking. We have built a basic evaluation framework and have applied this to a selection of Dutch energy policy instruments, namely production subsidies and their complementary non-financial instrument, DEN-B. Our evaluation criterion was effectiveness, defined as the extent to which policy instruments contribute to achieving policy goals. The evaluation was based on existing ex post evaluations complemented by interviews and other available data. We conclude that production subsidies and DEN-B were (partly) effective. Furthermore, the Dutch government increased effectiveness by reconsidering the design of production subsidies. We also formulate lessons for future policy evaluations and energy markets policies.